LCR-800 Series User Manual
26
4-5-8. Memory
The LCR Meters have two memory functions: Recall and Store. The current
measurement conditions can be saved into the memory unit or recalled a
previously saved measurement conditions set from the LCR Meters memory.
There are 100 memory blocks totally. The programming of “Memory Store /
Recall” can be used as described below (Figure 4-12):
! Press MENU key.
! Press F3 key to select “SETTING” menu.
! Press F1 key to select “MEMORY” menu.
! Press compound key 1 to recall a previously saved memory block. or
! Press compound key 2 to store the current measurement conditions into
memory.
! Input the number of desired memory block. (1~100)
! Press ↵
↵↵
↵ key
! After the BAR at the bottom of LCD monitor is filled to the full, the process
of “Memory Store/Recall” is done.
Remark: For LCR-827/829, the function of Recall and Store is not only used in
the normal memory status, also it can be extended to sorting and BIN-
SUM setting.
To Next Page
Loading...
