GW Instek LCR-800 Series - Setting the Measurement Delay; Setting the Averaging Value; BIN Range Setting for Component Sorting

LCR-800 Series User Manual
47
! Press F3 key to select FAST, SLOW or MEDI shown as Figure 8-4 below.
For further details, please refer to 4-4-5.
Figure 8-4
DISPLAY setting:
! Press F1/F2 key to select the white inverted characters “DISPLAY”.
! Press F3 key to select BIN, VAL or OFF shown as Figure 8-5 (When the
BIN is selected, BIN1~BIN13 represents PASS, while PHI, PLO, and SREJ
represents FAIL result. The VAL is to display test value while the OFF
represents as non-display.)
The display speed for above three selections is different from one another.
Figure 8-5
F setting (FREQUENCY):
! Press F1/F2 key to select the white inverted characters “F”.
! Key-in testing frequency through panel keyboard.
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
:SLOW DISPLAY:BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
RANGE:1 C.V : OFF
DELAY:00000mS AVG : 1
SET
Press F1 . F2
key to the
SPEED
SPEED
Press F3 key
to the FAST
SLOW.MEDI
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
SPEED:SLOW :BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
RANGE:1 C.V : OFF
DELAY:00000mS AVG : 1
SET
Press F1.F2
key to the
DISPLAY
DISPLAY
Press F3 key
to the BIN
VAL.OFF