LCR-800 Series User Manual
16
Steps of “Nominal Value” input (Figure 4-6):
! Press MENU key.
! Press F2 key to select “SORT” menu.
! Press F1 key to select “Nominal Value” (the “NOM.VAL” is indicated on
the adjacent LCD monitor).
! Input the nominal value via the numeral keys (5 digits with decimal
maximum).
! Press ↵
↵↵
↵ key
! After the BAR at the bottom of LCD monitor is filled fully, the “Nominal
Value” input is done.
4-4-5. Selection of Measurement Speed
One of three measurement speeds SLOW, MEDIUM, or FAST could be
selected (Figure 4-7). The continuous mode speeds are about 1, 5, and 12
measurement per second respectively. The trade-off is accuracy vs. speed. LCR-
817/819 will take a more accurate measurement at a slower rate. The trade-off is
as follows section
SLOW
speed : More than 1 measurement per second, at 0.05% accuracy (or
better)
MEDIUM
speed : More than 3 measurements per second, at 0.1% accuracy
(or better)
FAST
speed :
More than 7 measurements per second, at 0.24% accuracy
(or better)
* For the details of accuracy, please refer to the specifications.
* Regarding the models LCR-827 & 829, please refer to 4-6-2 Handler Interface
Timing.
To Next Page
Loading...
