GW Instek PEL-2000 Series - Editing CC;CR;CV A;B Value

PEL-2000 Series User Manual
118
Editing CC /CR/CV A/B Value
Background
The Selector Knob can be used to change the A
Value and B Value (single channel load module)
when in static mode.
Panel Operation
1. Ensure the mode is in static
mode.
Page 114
2. Choose a channel (or choose A
or B Value) by pressing the R/L
or A/B key.
3. Turn the Selector knob to edit
the A/B Value for the selected
mode.
Note
When the Slave Knob is set to “Measured”, the
selector knob must be pressed first to display the
values on the load module display.
All manuals and user guides at all-guides.com