GW Instek PEL-2000 Series - Page 133

OPERATION
133
Panel Operation
1. Use the Selector knob to
highlight A Value.
03/02/09
10 : 30
CR
Static
Low
ConfigureConfigure
Mode
CR
Static
CH1
Range
Low
Ω
Ω
Seq.
Edit
Main
2. Press the Selector knob to edit A
Value /B Value, then turn to
increase or decrease the value.
OR
Use the number pad to enter a
number.
3. Press the selector knob or Enter
to confirm selection.
4. Repeat steps 1-3 for B Value (if
applicable), rising and falling
SlewRate.
Note
A/B Value and rising/falling SlewRate can be set for
both High and Low Range.
All manuals and user guides at all-guides.com