GW Instek PEL-3111 - Page 17

Toggle Parameter or State
Mode
CC
Function/Item
Parameter or State
This type of soft-menu icon has the function/item
on the top of the label and the selected setting or
mode on the bottom of the label.
Repeatedly press the associated function key
(F1~F5) to cycle through each setting.
For some parameters, a popup window will also
appear. Selection of the setting is the same.
Repeatedly pressing the relevant function key
(F1~F5) will cycle through each setting.
Parameter Input
The scroll wheel, Enter key and number pad can be
used to edit parameter values.
1. Use the scroll wheel to move the cursor to the
desired parameter.
 A scroll bar is shown when there are additional
parameters off-screen.
Mode
CP
I Range
H 35A
V Range
L 15V
Function
Dynamic
Configure
0.000
V
0.000
A
0.00
w
Timer1 0.025
Level2 0.00
Level1 0.00
LOADRS232
Fine
03/Sep/2012
ms
W
W
Scroll bar
Cursor
2. Press the
Enter
key to select the parameter.
3. Then use umber pad* or scroll wheel** to edit the
parameter value.