Need help?Do you have a question about the GW Instek PEL-3021 and is the answer not in the manual?
General| Output Current | 0-21A |
|---|---|
| Power Rating | 300W |
| Display Type | LCD |
| Dimensions | 128mm x 145mm x 266mm |
| Weight | Approx. 2.5kg |
| CC Mode | Yes |
| CV Mode | Yes |
| CR Mode | Yes |
| CP Mode | Yes |
| Output Power | 300W |
| Voltage Resolution | 10mV |
| Operating Temperature | 0°C to 40°C |
| Output Voltage | 0-30V |
| Input Voltage | 100V to 240V AC |
| Current Accuracy | 0.1% + 0.1% of FS |
| Display | TFT LCD |
| Interface | USB, RS-232 |
| Storage Temperature | -10°C to 70°C |
Explains safety symbols used in the manual and on the instrument.
Provides essential guidelines for safe operation and handling of the instrument.
Guides users through initial setup steps like rack mounting and basic configuration.
Explains important considerations and procedures for connecting load wires.
Covers fundamental operating modes like CC, CR, CV, CP, and their setup.
Details the configuration and operation of the Constant Current (CC) mode.
Explains the setup and usage of the Constant Resistance (CR) mode.
Describes how to configure and operate the Constant Voltage (CV) mode.
Outlines the configuration and operation of the Constant Power (CP) mode.
Explains various protection functions (OCP, OPP, UVP, OVP) to prevent damage.
Explains external voltage and resistance control via J1 and J3 connectors.
Covers connecting multiple units in parallel for increased power capacity.
Details the setup for USB, GPIB, and RS232 remote control interfaces.
Provides comprehensive technical specifications for the PEL-3000(H) series.
To Next Page
