GW Instek PEL-3021 - PEL-3000(H) Specifications; Rating (Master; Slave); Rating (Booster; Slave)

PEL-3000(H) User Manual
234
PEL-3000(H) Specifications
The specifications apply when the PEL-3000(H) is powered on for
at least 30 minutes to warm-up to a temperature of 25˚C ± 5˚C,
unless specified otherwise.
All specifications apply when using the rear panel terminals. If the
front panel terminals are used or if operating with long cables,
remote sense must be connected to the terminals.
In parallel mode: All operation/settings/resolution specifications
are N times. This does not include voltage settings and measured
values. The maximum slew rate settings also don’t change.
N = Number of units in parallel (same model on master)
N = PEL-3111(H) + 2 x Number of units in parallel (PEL-3211(H))
Rating (Master / Slave)
Model
PEL-3021(H)
PEL-3041(H)
PEL-3111(H)
Voltage
0V-150V(0V-800V)
Current
35A(8.75A)
70A(17.5A)
210A(52.5A)
Min. Operating Voltage
1.5 V at 35A
(5V at 8.75A)
1.5 V at 70A
(5V at 17.5A)
1.5 V at 210A
(5V at 52.5A)
Power
175W
350W
1050W
Rating (Booster / Slave)
Model
PEL-3211(H)
Voltage
0V-150V(0V-800V)
Current
420A(105A)
Min. Operating Voltage
1.5 V at 420A (5V at 105A)
Power
2100W