PEL-3000(H) User Manual
166
Analog Control
The Analog Control subsection describes how to use the J1 Frame
Control Connector for voltage or resistance control. The J2
connector, located under the J1 connector is used for parallel
control. See page 216 for details about the J1 and J2 connectors.
J1 Connector Overview
The J1 External Control Connector is a standard
Mil 20 pin connector (OMRON XG4A IDC plug).
The connector is used for all analog control. The
pins are used to determine what mode is used.
See the appendix on page 216 to view the contact
pin assignment of the J1 connector.
Some pins on the frame control connector have the
same potential as the front and rear terminals.
To prevent electric shock, ensure that the cover for
both the J1 and J2 External Control connectors are
used when the connectors are not in use.
To Next Page
Loading...
