OPERATION
65
Basic Configuration
The basic configuration settings are the common configuration
settings that are used for each operating mode. After selecting a
basic operating mode (CC, CR, CV or CP mode), the slew rate,
switching function, response rate and other common parameters
should be configured.
Select the Switching Function
The PEL-3000(H) has two switching function, static
and dynamic. The switching function allows the
PEL-3000(H) to switch between two preset levels.
Static mode can only switch between the two levels
manually, while Dynamic mode switches between
each level automatically based on a timer.
Static mode: A Value, B Value
Dynamic mode: Level1, Level2
When the unit is set to static mode, only one value
(A Value or B Value) can be active at a time. The
active value is shown in the Operation Status
Panel.
Function
Static
Configure
0.00
W
LOADRS232
A Value
Fine
W
W
Active
setting
When the unit is set to dynamic mode, the unit will
switch between Level1 and Level2 based on the
Timer1 and Timer2 parameters, shown below.
To Next Page
Loading...
