REMOTE CONTROL
199
RS232C/USB Remote Control Function Check
Invoke a terminal application such as Realterm.
For RS-232C, set the COM port, baud rate, stop bit,
data bit and parity accordingly.
To check the COM settings in Windows, see the
Device Manager. For example, in WinXP go to the
Control panel → System → Hardware tab.
If you are not familiar with using a terminal
application to send/receive remote commands from
the serial port or via a USB connection, please page
200 (Using Realterm to Establish a Remote
Connection) for more information.
Run this query command via the terminal after the
instrument has been configured for
RS-232/USB remote control (page 198).
*idn?
This should return the Manufacturer, Model
number, Serial number, and Firmware version in
the following format.
GW-INSTEK,PEL-3000(H), XXXXXXXXXXXX,
V.X.X.X.X
Manufacturer: GW-INSTEK
Model number : PEL-3000(H)
Serial number : XXXXXXXXXXXX
Firmware version : V.X.X.X
For further details, please see the programming
manual, available on the GW Instek web site @
www.gwinstek.com.
To Next Page
Loading...
