Do you have a question about the Gyroor Hovershoes S300 and is the answer not in the manual?
Model | S300 |
---|---|
Charging Time | 1.5 hours |
Weight Limit | 220 lbs |
LED Lights | Yes |
Bluetooth | Yes |
Motor Power | 250W |
Remember that whenever you ride the Hovershoes, you risk injury or death from loss of control, collisions, and falls. You can reduce the risk by following all the instructions and warnings in this manual, but you cannot eliminate all the risks.
Always wear a helmet when riding. Use an approved bicycle or skateboard helmet that fits properly with the chin strap in place, and provides protection for the back of your head.
Do not attempt your first ride in any area where you might encounter children, pedestrians, pets, vehicles, or other obstacles. Respect pedestrians by always yielding the right of way.
Verify that the charger, mainframe X2, user manual, limited warranty, and welcome card are included in the package.
Identifies Power Level Indicator, Foot Mat, Power Button, Rubber Bumper, and Wheel in the side view.
Identifies Glow light, Charge Port, Handle, and Wheel in the bottom view.
Instructions on powering the Hovershoes on/off and understanding the glow light color for battery level.
Open the rubber cap, insert the plug into the charge port. Charge both mainframes simultaneously until the LED turns green.
Describes Standby Mode, Balance Mode, and how to control forward/backward movement and turning.
Read the User Manual and New Rider Tutorial. Ensure Hovershoes are powered on and stay on the ground to avoid injury.
Practice turning and swinging back and forth with one foot on the mat to feel the control.
Ask a friend for assistance, find an open area, place mainframes shoulder width apart, and put them into Balance Mode.
With assistance, place one foot on the mat, stand straight, and step up with the other foot, avoiding rocking.
Scan the QR code on the Welcome Card to follow the NewRiderTutorial for more ways to play.
Failure to follow warnings may result in death or serious injury due to loss of balance, traction, control, collisions, or falls.
Do not ride on public roads, traverse bumps, uneven terrain, slopes steeper than 10°, or through puddles/water.
Place the Gyroshoe upside down, power it off, and press the power button for 5 seconds until it beeps 3 times to complete calibration.
If Hovershoes exceed 122°F (50°C), glow lights flash red, an alarm sounds, and charging is disabled. Power off to cool.
For other alarms, try restarting the Hovershoes. If the problem persists, contact after-sales service.
Use a soft, wet cloth to wipe the mainframe clean. Stubborn dirt can be scrubbed with a toothbrush and toothpaste.
Do not wash with alcohol, gasoline, acetone, or use a power washer. Ensure powered off and port sealed before cleaning.
Store in a cool, dry place. Avoid outdoor storage and temperature extremes to preserve plastic components and battery life.
Charge after each ride, avoid complete draining. Battery performance is best at room temperature; cold affects range.
Details the size of the Hovershoes S300 and the payload and net weight.
Specifies the recommended age and weight limits for riders.
Includes max speed, riding time, slope limits, operating and storage temperatures.
Details nominal voltage, capacity, charging time, temperature, and charger input/output.
Declares compliance with Electromagnetic Compatibility Directive & Low-Voltage Directive.
GYROOR and Hovershoes are trademarks. Information on patents is available on the company website.
Notes that product details may differ from the manual and the manufacturer reserves the right to change design without notice.