GYS Start UP 80 User Manual

13
EN
START UP 80
Translation of the original instructions
CONNECTION IN CHARGER FUNCTION
Preliminary precautions
• For indoor use, with good ventilation.
• Remove the battery caps if there are, and check the level of liquid. If it is not correct, lled up with distilled water. Clean
well the battery terminals.
• Check if the battery capacity (Ah) and voltage (V) are compatible with your charger.
Connection and disconnection
• Do not connect to the mains supply at the beginning :
• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get a good electric
contact, respecting the following order.
◦ Connect rst the battery terminal not connected to the chassis of the vehicle.
◦ Then connect the other connection to the chassis remote from the battery and any fuel line.
• Switch on the CHARGE position.
• At last, plug in your charger to 230 V 50Hz mains supply.
• After charging :
◦ Disconnect the battery charger from mains supply.
◦ Then remove the chassis connection and the battery connection, in this order.
Automatic charge
The 3 red, orange and green indicators show the battery charge condition:
◦ Both red and orange indicators show the charge is in progress.
◦ At 14,8V; the green indicator shows the end of the charge. The charger automatically stops.
This function enables to let the battery indenitely in charge, without risk.
If the charger remains in charge more than 24h (red and orange indicators on), stop the charge (see sulfated batteries).
STARTER MODE USE (BOOST)
Prior precautions
• Do not disconnect the vehicle battery. The battery disconnecting can result in information loss and in an evenutal
restarting impossibility.
• The engine must be stopped.
Connection and disconnection
Do not connect to the mains supply at the beginning:
• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get a good
electric contact.
• Switch on the BOOST position.
• Plug in your charger to 230 V 50 Hz mains supply.
• Let in charge for 10 minutes. This pre-charge is necessary to bring the energy for an eventual
start.
• By switching on the ignition key, you will activate the STARTER function. This function provides
only a part of the energy needed to start the engine.
130.ua — all for cars!
130.ua

GYS Start UP 80 Specifications

General

Charging source	AC
Battery capacity	- mAh
Battery technology	-
Number of simultaneously connected devices (max)	1
Built-in display	No

Weight and Dimensions

Depth	180 mm
Width	120 mm
Height	320 mm
Weight	4400 g