How to troubleshoot input failure on AC-powered H3C S5120V2-LI Switch?
To troubleshoot an AC-powered H3C switch that's not receiving power, make sure the AC power cord is properly connected to both the switch and a working AC outlet. Also, ensure the switch's operating temperature is within the acceptable range and that the power module has adequate ventilation. Overheating can trigger a protective shutdown.
What to do if there is an input failure on an RPS and AC-powered H3C switch?
If your H3C switch, powered by both RPS and AC, is experiencing input failure, verify that the AC power cord is securely connected to the switch and a functioning AC outlet. Also, check the connection to the RPS and confirm the RPS is operating correctly. Ensure the switch's temperature is within the acceptable range and that the power module has sufficient ventilation.
How to fix no display on the configuration terminal of H3C S5120V2-LI?
To resolve a missing display on the configuration terminal of your H3C switch, first ensure the power system and the switch itself are working correctly. Verify the console cable is properly connected and not faulty. Finally, confirm that your terminal settings are: Baud rate—9600, Data bits—8, Parity—None, Stop bits—1, Flow control—None.
How to troubleshoot input failure on RPS-powered H3C Switch?
To troubleshoot an RPS-powered H3C switch that's not receiving power, verify that the switch is securely connected to the RPS and that the RPS is functioning correctly. Additionally, ensure the switch's operating temperature is within the acceptable range and that the power module has good ventilation. Over-temperature can cause the power module to stop working and enter protection state.
How to resolve garbled display on the configuration terminal of H3C Switch?
To address a garbled display on the configuration terminal of your H3C switch, verify that the terminal settings are configured as follows: Baud rate—9600, Data bits—8, Parity—None, Stop bits—1, Flow control—None.
What to do if hot-swappable power module failure in H3C S5120V2-LI Switch?
To troubleshoot a hot-swappable power module failure in your H3C switch, ensure that the power module model is the one required and is correctly installed in the switch. Also, verify that the switch is operating within the acceptable temperature range.
Covers safety guidelines, site examination, environmental conditions, and laser safety.
Guides on installing the switch in a 19-inch rack, including bracket selection and attachment.
Essential steps for grounding the switch and connecting power cords.
Instructions for accessing and managing the switch via its web-based Graphical User Interface.
Methods for accessing and configuring the switch using the Command Line Interface.
Configuring basic IRF settings, connecting physical ports, and verifying the fabric.
General| Model | H3C S5120V2-LI |
|---|---|
| MAC Address Table Size | 16K |
| VLAN Support | 4K VLANs |
| Storage Temperature | -40°C to 70°C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Storage Humidity | 5% to 95% (non-condensing) |
| Switching Capacity | 176 Gbps |
| Jumbo Frame | 9KB |
| Power Supply | AC 100-240V |
| Dimensions (W x D x H) | 440 mm x 260 mm x 43.6 mm |
| Operating Temperature | 0°C to 45°C |
To Next Page