14
Figure 20 Locating the NVMe drive
Configuring RAID arrays in legacy mode
NVMe VROC in legacy mode does not support RAID configuration.
Configuring RAID arrays in Linux
RAID array configuration tasks at a glance
To configure RAID arrays in Linux, perform the following tasks:
Configuring VMD settings
Accessing NVMe RAID configuration screen
Configuring RAID arrays
(Optional.) Configuring hot spare drives
(Optional.) Deleting RAID arrays
Configuring VMD settings
For information about how to configure VMD settings, see "Configuring VMD settings."
Verifying VMD status
1. Access the CLI of the server.
2. Execute the
mdadm –-detail-platform command to examine VMD status, as shown in
Figure 21:
If the screen displays the Platform and Version fields, it indicates that VMD has been
enabled, and the server supports configuring RAID arrays.
To Next Page
Loading...
Need help?
General
