Need help?Do you have a question about the H3C UniServer R6900 G3 and is the answer not in the manual?
General| Processor | Intel Xeon Scalable processors |
|---|---|
| Maximum Processors | 2 |
| RAID Support | Supports RAID 0, 1, 5, 6, 10, 50, 60 |
| Network Interface | Integrated Gigabit Ethernet ports |
| Power Supply | Redundant power supplies |
| Operating System Support | Windows Server, Linux, VMware |
| Form Factor | 2U Rack |
Explains the meaning of safety signs found on the server chassis and components.
Provides essential safety guidelines for operating the server and its modules.
Details safety precautions related to electrical hazards and power connections.
Explains methods to prevent electrostatic discharge damage to sensitive components.
Detailed procedure for mounting the server into a rack using slide rails.
Procedure for connecting the server's power cord to a power source.
Describes methods to power on the server using the front panel or remote interfaces.
Details procedures for safely shutting down the server from OS or hardware.
Explains how to adjust BIOS settings like boot order and passwords.
Guide for installing the server's operating system and necessary hardware drivers.
Guidelines and steps for installing SAS/SATA storage drives.
Procedure for installing server power supply units, including redundancy.
Procedure for installing compute modules into the server chassis.
Procedures for installing riser cards and PCIe modules into compute modules.
Steps for installing storage controllers and associated safeguard modules.
Guidelines and procedures for installing GPU modules into compute modules.
Guidelines and procedures for installing server processors.
Information and procedures for installing DIMM memory modules.
Procedure to replace the compute module and its main board assembly.
Procedure for replacing server power supplies, which are hot-swappable.
Procedures for replacing riser cards and PCIe modules in compute modules.
Procedures for replacing riser cards and PCIe modules at the server's rear.
General procedure for replacing server storage controllers.
General procedures for replacing GPU modules in compute modules or at the server rear.
Guidelines and procedures for replacing server processors.
Procedure for replacing DIMM memory modules.
Procedure for replacing the server's management module.
Procedures for removing and installing the Power Distribution Board (PDB).
Procedures for removing and installing the server midplane.
Detailed specifications for Intel SkyLake and Jintide-C series processors.
Specifications for different GPU modules supported by the server.
Specifications for different wattage power supplies, including redundancy.
Steps for safely removing NVMe drives while the server is running in Windows.
Steps for safely removing NVMe drives in Linux via CLI or Intel ASM.
To Next Page
