Need help?Do you have a question about the H3C UniServer R4900 G5 and is the answer not in the manual?
General| Form Factor | 2U Rack |
|---|---|
| Processor | Intel Xeon Scalable Processors |
| Maximum Processors | 2 |
| Memory Slots | 32 DIMM slots |
| Storage | Up to 24x 2.5" or 12x 3.5" drives |
| Operating System Support | Windows Server, Linux |
| RAID Support | RAID 0/1/5/10/50/60 |
Details various methods for configuring RAID arrays on storage controllers.
Explains hot spare drive functionality and types for fault tolerance.
Describes the process and scenarios for RAID rebuild after drive replacement.
Explains the copyback process for hot spare drives and its impact.
Details how to change RAID levels without compromising data integrity.
Explains methods to increase the capacity of a RAID array.
Describes migrating logical drives to different physical drives.
Explains the cache feature for faster read/write speeds and its policies.
Details clearing RAID information from drives before reconfiguring.
Describes the power fail safeguard module for data security.
Details the process of updating storage controller firmware online.
Details configuring the embedded RSTe or VROC SATA RAID controller.
Details configuration of the NVMe VROC module.
Explains how to configure VMD settings for NVMe RAID.
Details configuration for RAID-P430-M1/M2 controllers.
Guides on creating RAID arrays using the PMC RAID utility.
Details configuration for HBA-1000-M2-1 controllers.
Details configuration for LSI 9400/9500 series controllers.
Guides on configuring controller settings in UEFI mode.
Details configuration for H460/P460/P2404/P4408 controllers.
Guides on configuring RAID arrays through UEFI mode.
Guides on upgrading storage controller firmware.
Details configuration for HBA-LSI-9300-8i controllers.
Details configuration for HBA-LSI-9311-8i controllers.
Guides on configuring RAID arrays in legacy mode.
Explains configuring hot spare drives.
Details configuration for RAID-MARVELL-SANTACRUZ-LP-2i controller.
Details creating RAID arrays.
Troubleshooting steps for drive failures.
Troubleshooting steps for RAID array failures.
Guides on replacing a storage controller.
Steps to help the system identify a new storage controller.
Explains factors affecting logical drive failure probability.
Provides rules for selecting an appropriate RAID level.
To Next Page
