64
hen switching the storage controller to JBOD mode, you can also change logical drives
managed by the controller to JBOD mode at the same time.
Be careful that data might be
logical drives that do not support JBOD mode once you switch the mode. For
example, logical drives in RAID
5, RAID 6, RAID 50, or RAID 60 managed by
-LSI-9560-LP-8i-4GB storage controller do not support JBOD mode and will be c
leared if
you switch their mode. For more information, see the screen prompt.
Figure 114 Confirming the mode switching
6. Select OK and press Enter to reboot the operating system for the change to take effect.
Figure 115 Completing the mode switching
Configuring RAID arrays in legacy mode
This section describes how to configure RAID arrays through a storage controller in legacy mode.
For more information about how to enter the BIOS and set the boot mode to legacy, see the BIOS
user guide for the server.
Only the LSI-9361 series storage controllers support RAID array configuration in legacy mode. The
other storage controllers support displaying managed physical drives and logical drives on the
POST screen in legacy mode, but do not support accessing the storage controller configuration
screen.
To Next Page
Loading...
Need help?
General
