7-25
Replacing an mLOM Ethernet adapter
The procedure is the same for mLOM Ethernet adapters of different models. This section uses the
NIC-GE-4P-360T-L3-M mLOM Ethernet adapter as an example.
Procedure
1. Power off the server. For more information, see "Powering off the server."
2. Disconnect external cables from the riser card that holds the mLOM Ethernet adapter.
3. Remove the riser card. For more information, see "Replacing a riser card and PCIe module at
the serve
r rear."
4. Remove the mLOM Ethernet adapter, as shown in Figure 7-30:
a. Open the
riser card cover. For more information, see "Installing riser cards and PCIe
module
s at the server rear."
b. Remove the screw that secures the mLOM Ethernet adapter, and then pull the Ethernet
adapter out of the slot, as shown in Figure 7-30.
Figure 7-30
Removing an mLOM Ethernet adapter
5. Install a new mLOM Ethernet adapter. For more information, see "Installing an mLOM Ethernet
adapter."
6. Install the riser card. For more information, see "Installing riser cards and PCIe modules at the
serv
er rear."
To Next Page
Loading...
Need help?
General
