29
1. Enter the BIOS and select boot options. For more information, see "Selecting the boot media."
2. Select Red Hat Enterprise Linux 7.2, and then press e as prompted, as shown in Figure 54.
Figure 54 Confirming OS installation
3. Input linux dd at the end of the line that starts with linuxefi, and then press F10 or Ctrl+X to
start installation.
Figure 55 Parameter configuration
4. Perform the following steps to configure the parameters:
a. Display the location of the driver. In this example, sr1 has a driver mounted, so you select
13.
b. Enter 1 to select the rpm file.
c. Enter c to continue installation.
If not all drivers are listed on the page, enter r to refresh the driver list.
To Next Page
Loading...
