65
RAID array configuration tasks at a glance
To configure a RAID array in legacy, perform the following tasks:
Accessing the storage controller configuration screen
Switching the drive state
Configuring a RAID array
(Optional.) Configuring hot spare drives
(Optional.) Deleting a RAID array
(Optional.) Locating drives
(Optional.) Initializing a virtual drive
(Optional.) Erasing drives
(Optional.) Expanding a RAID array
(Optional.) Clearing RAID array information on the drive
(Optional.) Configuring boot options
Accessing the storage controller configuration screen
1. During server POST, press Ctrl+R as prompted as shown in Figure 116.
Figure 116 Pressing Ctrl+R
2. On the screen as shown in Figure 117, follow the instructions at the bottom of the screen to
navigate through screens and modify settings.
To Next Page
Loading...
