H3C WA Series

7-6
Task Remarks
Configuring a Priority Mapping Table Optional
Configuring a Port to Trust Packet Priority for Priority Mapping Optional
Changing the Port Priority of an Interface Optional
Configuring Priority Mapping
Configuring a Priority Mapping Table
Follow these steps to configure a priority mapping table:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter priority mapping table view
qos map-table
{
dot11e-lp
|
dot1p-lp
|
dscp-lp
|
lp-dot11e
|
lp-dot1p | lp-dscp
}
Required
You can enter the corresponding
priority mapping table view as
required.
Configure the priority mapping
table
import
import-value-list
export
export-value
Required
Newly configured mappings
overwrite the previous ones.
Display the configuration of the
priority mapping table
display qos map-table
[
dot11e-lp
|
dot1p-lp
|
dscp-lp
|
lp-dot11e
|
lp-dot1p
|
lp-dscp
]
Optional
Available in any view
Configuring a Port to Trust Packet Priority for Priority Mapping
You can configure the AP to trust a particular priority field carried in packets for priority mapping on ports
or globally.
When configuring the priority trust mode for a port, you can select the following keywords:
z dot11e: Uses the 802.11e priority of the received packets for mapping.
z dot1p: Uses the 802.1p priority of the received packets for mapping.
z dscp: Uses the DSCP value of the received packets for mapping.
Follow these steps to configure the priority trust mode for a port:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter interface view
interface
interface-type
interface-number
—
Configure the priority trust mode
qos trust
{
dot11e
|
dot1p
|
dscp
} Required
Display the priority trust mode and
port priority information of the
specified interface or all interfaces
display qos trust interface
[ interface-type interface-number ]
Optional
Available in any view