10
○ If mounting to a US electrical box (83.3mm), use 2 threaded screws and insert
into the holes marked “B” in the diagram shown below.
2. Connect the Ethernet cable (for power and network connection) to the LAN port
on the back of the AP.
3. To mount the AP onto the mounting bracket, insert the mounting-bracket tabs into
the slots on the back of the AP.
CAUTION:
If you are mounting the AP on a wall, you cannot use the slots on the bottom narrow edge of the
device. Instead, you must use the slots on back of the AP.
Tabletop mounting
To install the AP on a flat surface such as a table or desktop using the table stand:
1. Insert the tabs on the table stand into the slots on the side of the AP (see Figure 3
Align the cable routing cut-out toward the upper part of the stand.
Figure 3 Connecting table stand to AP
2. To lock the stand to the AP, slide the stand back and the AP forward (see Figure 4
To Next Page
Loading...
