131
Figure 131 Enable DHCP
2. Enable the DHCP server on VLAN-interface 1: (This operation can be omitted because the DHCP
server is enabled on the interface by default.)
a. Click the icon of VLAN-interface 1 in the Interface Configuration field.
b. Select the Enable option for DHCP Server as shown in Figure 132.
c. Cli
ck Apply.
Figure 132 Enable the DHCP server on VLAN-interface 1
3. Configure a dynamic address pool for the DHCP server:
a. Select the Dynamic option in the Address Pool field (default setting) and click Add to enter the
page as shown in Figure 133.
b. T
o configure a dynamic address pool for the DHCP server:
− Enter test for IP Pool Name.
− Enter 10.1.1.0 for IP Address.
− Enter 255.255.255.0 for Mask.
− Enter 10 days 12 hours 0 minutes 0 seconds for Lease Duration.
To Next Page
Loading...
