12-3
<Sysname> display ipv6 fibcache
FIB Cache:
Total number of Routes : 0
display ipv6 interface
Syntax
display ipv6 interface [ interface-type [ interface-number ] ] [ verbose ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type: Interface type.
interface-number: Interface number.
verbose: Displays detailed IPv6 information of an interface.
Description
Use the display ipv6 interface command to display the IPv6 information of an interface for which an
IPv6 address can be configured.
If interface-type interface-number is not specified, the IPv6 information of all interfaces for which IPv6
addresses can be configured is displayed; if only interface-type is specified, the IPv6 information of the
interfaces of the specified type for which IPv6 addresses can be configured is displayed; if the
interface-type interface-number is specified, the IPv6 information of the specified interface is displayed.
Examples
# Display the IPv6 information of VLAN-interface 2.
<Sysname> display ipv6 interface vlan-interface 2 verbose
Vlan-interface2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::1234:56FF:FE65:4322
Global unicast address(es):
2001::1, subnet is 2001::/64
10::1234:56FF:FE65:4322, subnet is 10::/64 [AUTOCFG]
[valid lifetime 4641s/preferred lifetime 4637s]
Joined group address(es):
FF02::1:FF00:1
FF02::1:FF65:4322
FF02::2
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 0
To Next Page
Loading...
