17
96-0112 Rev W
July 2010
ipS recorder
The IPS recorder provides a simple method to place G-code generated by IPS
into new or existing programs.
1. To access IPS, press MDI/DNC, then PROGRM/CONVRS. Refer to your
Intuitive Programming System Operator Manual (ES0609 Lathe) for more
information on using IPS.
2. When the recorder is available, a message appears in red in the lower right
corner of the tab:
VQCGROOVINGTHREADINGDRILL & TAP
MANUAL
CHAMFER AND RADIUS
TOOL NUMBER
WORK OFFSET
Z START PT
DIA TO CUT
Z DIMENSION
DEPTH OF CUT
MAX RPM
SFM
1 1000
54 0.0000 in 200
0.0000 in 0.0500 in
RAPID
Press <CYCLE START>
to run in MDI or <F4>
to record output to a
program.
SETUP TURN & FACE
FILLET RADII
0.0000 in
OUTSIDE DIA.
FEED PER REV
0.0000 in 0.0100 in
TOOL NOSE
0.0315 in
0.0000 in
FEED OD TURN ID TURN FACE PROFILE
3. Press F4 to access the IPS recorder menu. Choose menu option 1 or 2 to
continue, or option 3 to cancel and return to IPS. F4 can also be used to
return to IPS from any point within IPS recorder.
0.0500 in
Press <CYC
to run in MDI
to record outp
program.
0.0000 in
ED PER REV
0.0100 in
TOOL NOSE
0.0315 in
IPS RECORDER F4 CANCEL
1. ) Select/Create Program
2. ) Output to current program
3. ) Cancel
IPS Recorder Menu
Menu Option 1: Select / Create Program
Select this menu option to choose an existing program in memory or to create
a new program into which the G-code will be inserted.
To Next Page
Loading...
