Need help?Do you have a question about the Haas TL-1 and is the answer not in the manual?
General| Tailstock Taper | MT3 |
|---|---|
| Max Cutting Length | 30 in |
| Swing Over Front Apron | 16 in |
| Swing Over Cross Slide | 8.5 in |
| Spindle Bore | 1.75 in |
| Spindle Motor Power | 7.5 hp |
| Z Axis Travel | 30 in |
| Swing Over Bed | 16 in |
| Distance Between Centers | 30 in |
Safety practices for workholding equipment and machine operation.
Instructions for removing shipping brackets from TL-1/2/3 and TL-4 models.
Procedure for leveling the machine using a machinist's level.
Detailed steps for leveling the TL-4 model, including specific screw adjustments.
Steps for powering on the lathe and initiating the homing sequence.
Steps to reinstall and realign the TT-4 tool turret after removal.
To Next Page
