20
96-0112 Rev W
July 2010
1. X-axis cross-slide trucks
2. X-axis cross-slide ball screw
3. Z-axis saddle trucks
4. Tailstock screw
5. Z-axis saddle ball screw
6. Tailstock base; two places (one on either side).
The spindle is grease packed and needs no routine maintenance.
chip filter
The chip lter is provided with the Coolant Pump Kit option (standard with the
TL-4).
Check the chip lter on a weekly basis. After removing and cleaning the chip
lter, make sure the basket has been emptied of chips before restarting the
machine.
See the Operator’s Manual for additional maintenance issues.
To Previous Page
Loading...
