48
SECTION 6, continued
6.3.2 Sending Recalled Data
To transfer recalled data:
1. Remove the instrument cap and slide the DTA onto the
instrument until snug.
2. Make sure the DTA is properly connected to the computer or
printer. (See Section 6.2 RS232 Connections.)
3. Recall the data to be transferred (see Section 5.1 Recalling
Data on page 39).
4. When sample data is displayed, press the
PRINT key. Four
horizontal lines and
PRINT are displayed while the data is
transmitted to the DTA.
6.3.3 Sending All Stored Data
All data stored in memory may be sent to a printer or computer
via the
SETUP menu option as follows:
1. Remove the instrument cap and slide the DTA onto the
instrument until snug.
2. Make sure the DTA is properly connected to the computer or
printer. (See Section 6.2 RS232 Connections.)
3. Press the
SETUP key.
4. Scroll, using the down
ARROW key, to the PRINT option.
5. Press the
ENTER key when the word ALL is displayed above
PRINT. All stored data is now sent to the DTA. After the data
has been successfully sent, the instrument defaults to the last
used program.
Transferred data will include the following information:
• instrument model number
• instrument serial number
• instrument software version
• date
To Next Page
Loading...
