Install the sample cell and cell adapter
The instrument
has one cell compartment which can use one adapter for
different sample cell types. Make sure to install the sample cell in the
correct orientation and in a consistent orientation so that the results are
more repeatable and precise. Refer to Figure 4. Close the instrument
cap before the instrument zero is set or a measurement is made to
prevent light interferences. Refer to Figure 5.
Figure 4 Sample cell orientation
1 1-cm/10-mL plastic sample cell 4 Orientation mark
2 1-inch (25 mm) glass sample cell 5 Orientation position (clockwise)
3 16-mm glass test vial 6 Sample cell adapter
English 7
To Next Page
Loading...
