Table 7 System Diagnostics screen example - Clock battery failure (continued)
Signal Value Status
Battery 2 (top) 16.44 VDC PASS
Laser current N/A – –
For troubleshooting that involves technical support from the manufacturer, the user may need to fax
a system status printout to technical support.
1. On the Counter Navigation screen, push DIAGNOSTICS.
2. Go to the Counter tab to see information about the system, such as serial number, model and
calibration date.
3. Go to the Calibration tab to see current calibration information.
4. On the Diagnostics screen, push PRINT.
The printout will show the serial number, date and time and other data about the system.
Factory settings
For troubleshooting that involves technical support from the manufacturer, the user may need
to send a copy of the factory settings to technical support.
Note: Factory settings cannot be changed by the user.
To view the factory information including the calibration date:
1. Log on as an administrator.
2. On the Counter Navigation screen, push FACTORY. The factory settings show (e.g., calibration
date, calibration due date and nominal flow).
3. Push to print the factory settings.
Parts and accessories
W A R N I N G
Multiple hazards. Use only the replacement parts and accessories specified by the manufacturer.
Parts for the 28.3 LPM counter (3413 and 3415)
Description Quantity Item number
Probe, isokinetic, aluminum, for 28.3 LPM 1 2087966-01
Probe, isokinetic, stainless steel, for 28.3 LPM 1 2087966-02
Filter, Zero Count for 28.3 LPM 1 2087939-01
Tubing, Hytrel
®
, 0.953 cm (0.375 in.) ID, 1.27 cm (0.5 in) OD 10 ft 960380
Parts for the 50 LPM counter (3423 and 3425)
Description Quantity Item number
Probe, isokinetic, aluminum, for 50 LPM 1 2088925-01
Probe, isokinetic, stainless steel, for 50 LPM 1 2088925-02
42 English
To Next Page
Loading...
