Hach MET ONE 3445 - User Manual

DOC026.53.80202
MET ONE 3400: 3413, 3415,
3423, 3425, 3445
06/2013, Edition 5, Firmware version 4.08.XX
User Manual

Hach MET ONE 3445 Specifications

General

Brand	Hach
Model	MET ONE 3445
Category	Cash Counter
Language	English

Summary

Specifications

Instrument specifications

Details the technical specifications of the MET ONE 3400 instrument, including power, interface, and dimensions.

Sample measurement specifications

Outlines performance parameters for sample measurement, including flow rate, zero count, and coincidence loss.

General Information

Safety information

Covers essential safety guidelines, hazard information, and precautionary labels for instrument operation.

Use of hazard information

Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE symbols used in the manual.

Precautionary labels

Describes instrument symbols and their corresponding safety meanings.

Installation

Unpack the instrument

Instructions for unpacking the instrument and inspecting for damage or missing items.

Wiring safety information

Provides crucial safety warnings regarding electrical connections and power disconnect.

Electrostatic discharge (ESD) considerations

Details precautions to prevent damage to internal components from static electricity.

Electrical connections

Explains how to connect probes, external power, cables, and USB devices to the instrument.

Network and Communications

Setup for serial communication

Details configuration steps for serial communication (RS232/RS485).

Setup for Ethernet communication

Provides instructions for configuring Ethernet network connections.

Setup for wireless communication

Guides on setting up wireless (Wi-Fi) communication for the instrument.

Set wireless security

Explains how to configure security settings for wireless network connections.

Configuration

Set the operation mode at initial startup

How to set the instrument's operation mode (Basic or Advanced) during initial startup.

Configure the system

Explains how system settings control data, permissions, and parameters.

Set the time and date

Procedure for setting the instrument's current time and date.

Manage Units and Alarms

Set the Alarm Reasons option

Enables/disables alarm reasons and sets them as Required, Optional, or Disabled.

Locations, Areas, and Groups

Location management

Area management

Group management

Data Management

Manage the data buffer

Set the data buffer to rotate data

Set the data buffer size

Manage Users and Permissions

Enable the user logon function

Log on as administrator

Change the password

Replace a forgotten password

Operation

Log on to the particle counter

Measure particle counts

Detailed procedure for performing particle count measurements.

How to Use the Test and Report Wizard

Set up the Test and Report Wizard

Step-by-step guide to configure the Test and Report Wizard with applicable options.

How to Use the Print Center

Start sample measurement with the Wizard

Instructions to begin sampling and perform measurements using the wizard.

Maintenance

Update the instrument software

Steps for updating the instrument's software using a USB drive.

Diagnostics and Troubleshooting