Hach MET ONE 3445 User Manual

Network and communications
N O T I C E
Only qualified personnel should perform the tasks described in this section.
About network and communications setup
This section shows the setup for:
• Serial communications
• Ethernet network communication
• Wireless (Wi-Fi) communication
• Wireless security
Setup for serial communication
N O T I C E
RS232 communication and manifold support cannot be used together because they use the same serial port.
1. On the Counter Navigation screen, push NETWORK.
2. Select the Serial tab.
3. Configure these options:
• Select FX or Modbus RTU.
• Set the ID for FX or Modbus.
• Set the Baud rate.
• Select RS232 or RS485.
• Activate Manifold Support as needed (RS485 only).
• Activate Auto Increment Port as needed
Setup for Ethernet communication
1. On the Counter Navigation screen, push NETWORK.
2. Select the Ethernet tab.
3. Configure these options:
• Select FX or Modbus protocol.
• Enter the Modbus port number.
• Enter the Configuration port number.
• Enter the IP address or select DHCP to let the network assign the IP address.
• Enter the subnet mask address.
• Enter the gateway address.
Setup for wireless communication
1. On the Counter Navigation screen, push NETWORK.
2. Select the Wi-Fi Configuration tab.
3. Configure these options:
• Enter the Network name.
• Select the data rate.
• Select the network type: Ad hoc or infrastructure.
• Enable auto fallback as needed.
English
17

Hach MET ONE 3445 Specifications

General

Brand	Hach
Model	MET ONE 3445
Category	Cash Counter
Language	English