Need help?Do you have a question about the Hach sc200 4-20 and is the answer not in the manual?
General| Operating Temperature | -20 to 60 °C (-4 to 140 °F) |
|---|---|
| Power Requirements (Voltage) | 100-240 VAC, 50/60 Hz |
| Power Requirements (Power Consumption) | 20 VA max. |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Operating Humidity | 5 to 95% RH, non-condensing |
| Outputs | 4-20 mA |
| Relay Contact Rating | 5 A at 250 VAC, 5 A at 30 VDC |
| Digital Communication | Modbus RTU, HART |
| Enclosure Rating | NEMA 4X/IP66 |
| Display | LCD |
| Dimensions | 144 x 144 mm |
| Relay Output | Two SPDT (single pole double throw) relays |
Defines DANGER, WARNING, CAUTION, and NOTICE symbols and their meanings.
Explains symbols found on the instrument and their safety implications.
Warnings about electrocution hazards and the need to disconnect power.
Warning about potential damage to internal components from static electricity.
Steps to configure module name, units, parameter, and display range.
Detailed steps for performing a single-point calibration process.
Detailed steps for performing a two-point calibration process.
Procedure to access and view sensor diagnostic data like signal and calibration values.
Steps to view module information such as software version and serial number.
To Next Page
