What does it mean when my Hach SOLITAX sc Accessories display 'CAL. DATA'?
The 'CAL. DATA' message on your Hach Accessories means that the factory calibration data has been lost. It is recommended to contact customer service.
What to do if Hach SOLITAX sc Accessories display 'REPLACE WIPER'?
If the Hach Accessories display shows 'REPLACE WIPER', it means the counter has elapsed. You should replace the wiper and then reset the counter.
What to do if Hach SOLITAX sc display 'POS. UNKNOWN'?
If the Hach Accessories display shows 'POS. UNKNOWN', the wiper position is unknown. Try opening the TEST/MAINT menu and triggering the 'WIPE' function. If the problem persists, it's recommended to contact the manufacturer's customer service.
Why does my Hach Accessories display 'MOIST'?
The 'MOIST' message on your Hach Accessories indicates that the moisture value is greater than 10. You should immediately remove the sensor and store it in a dry place. It's also advisable to contact customer service.
What does 'LED FAULTY' mean on my Hach SOLITAX sc Accessories?
The 'LED FAULTY' message on your Hach Accessories indicates a faulty LED. It is recommended to contact customer service.
Why does my Hach SOLITAX sc Accessories display 'TEST/MAINT'?
The 'TEST/MAINT' message on your Hach Accessories indicates that a counter has elapsed. It is recommended to contact customer service.
Why does my Hach Accessories display 'GASKET'?
The 'GASKET' message on your Hach Accessories indicates that a counter has elapsed. It is recommended to contact customer service.
General| Brand | Hach |
|---|---|
| Model | SOLITAX sc |
| Category | Accessories |
| Language | English |
Provides crucial safety instructions and hazard warnings for operating the instrument.
Guide for installing immersion type sensors in open tanks, including placement considerations.
Instructions for installing sensors in pipes, covering flow direction and placement.
Procedure for connecting the sensor cable to the controller socket.
Procedures and settings for calibrating the sensor for turbidity and suspended solids.
Configure output behavior during calibration (Active, Hold, Transfer).
Procedure for calibrating turbidity measurements using standard solutions.
Procedure for calibrating suspended solids measurements using actual samples.
Instructions and precautions for cleaning the sensor's optical windows.
Step-by-step guide for replacing the sensor wiper assembly.
Lists common error messages, their causes, and recommended solutions.
Explains warning indicators, their causes, and the actions to take.
To Next Page
