www.haden.com www.haden.com10 11
• When frothing of the milk is complete, you can turn the
steam knob back to the OFF position.
• Best temperature for frothed milk is 70ºC. There will be
plenty of steam coming from it.
• After frothing the milk, put an empty jug under the steam
wand, then turn on the steam knob and press down the
coffee button for 30 seconds, then turn it off again. This
will clean out the steam tube.
• Finally, clean the steam wand with a wet sponge, but take
care not to get burnt!
• Press and release the ON/OFF button to switch the machine
off.
• Pour the frothed milk into the prepared espresso. Now the
cappuccino is ready.
• Sweeten if desired and sprinkle the froth with a little cocoa
powder.
WARNING: After finishing the “Steam” function, press
the coffee switch, if the coffee indicator is blinking fast,
it means that the temperature of the appliance is too
high and the appliance needs to be turned off and have
a rest for more than 5 minutes, or you can activate the
“Hot water” function to cool down the appliance. When
the indicator light stops flashing quickly, press the coffee
button again,the pump stops working and the coffee can be
brewed normally.
When the preheating is finished, the coffee indicator lights up
solidly. Then press the coffee button and the water pump
starts to pump water. Turn the steam knob to “Hot water”, and
then hot water will flow out of the steam pipe. To stop making
hot water, press the coffee switch again. Hot water is used for
warming cups, making tea or cooling down the appliance.
NOTE: The maximum working time of the hot water pump is
60 seconds.
If there is no operation within 25 minutes, the appliance will
power off automatically.
• Cut off power source and let the coffee maker cool down
completely before cleaning.
• Clean housing of coffee maker with moisture-proof sponge
often and clean water tank, drip tray and removable shelf
regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never
immerse the housing in water for cleaning.
• Detach the metal funnel by turning it clockwise, get rid of
coffee residue inside, then you can clean it with cleanser, but
at last you must rinse with clear water.
• Clean all the attachments in the water and dry thoroughly.
HOT WATER
AUTO POWER OFF
CLEANING AND MAINTENANCE
To Next Page
Loading...
