www.haden.com www.haden.com12 13
To ensure your coffee maker can operate efficiently the internal
piping must be clean so as not to affect the flavour of the coffee.
You should clean away the mineral deposits left every 4 weeks
- if you live in a hard water area every 2 weeks. Or you can use
bottled water and none of this will be necessary!
1 Fill the tank with water and descaler to the MAX level (the
scale of water and descaler is 4:1, the detail refers to the
instruction of descaler. Please use “household descaler”, you
can use the citric acid (obtainable from chemist’s or drug
stores) instead of the descaler (the one hundred parts of
water and three parts of citric acid).
2 Press the ON/OFF button to turn on the unit, and the coffee
button indicator will start blinking. After finished
preheating, the coffee indicator light stop blinking and turn
solid blue.
3 Press the coffee button , when there is water flowing
out, close the pump immediately.
4 Once the coffee indicator light stops blinking, press the coffee
button and allow two coffee cups of water flow out of the
unit. Then press the coffee button again to stop.
5 Press the steam button , the indicator light will start to
blink. Wait for the light to stop blinking indicating it’s reached
the correct temperature.
6 Place a cup under the steam wand and open the Steam knob
and steam for 2 minutes, then turn the Steam knob to the off
position.
7 Press the ON/OFF button to turn on the unit immediately,
leave the descaler in the unit for at least 15 minutes.
8 Empty the tank and refit with clean water. Restart the unit and
repeat the above steps at least 3 times - with clean water.
DESCALING TROUBLESHOOTING
Problem Cause Solution
Metal parts in the
tank have rust.
The descaler is not a
recommended type. It may
corrode the metal parts in
the tank.
Use the descaler
recommended by
manufacturer.
Water leaks from
the bottom of the
coffee maker.
There is too much water in
the drip tray.
Please clean the drip tray.
The coffee maker is
malfunction.
Contact the authorised
service for repairing.
Water leaks
out of outer side
of filter.
There is some coffee powder
on filter edge.
Get rid of them.
Acid (vinegar)
taste exists in
Espresso coffee.
Not cleaned correctly after
cleaning mineral deposits.
Clean coffee maker several
times. Refer to “before the
first use”.
The coffee powder is stored
in a hot, wet place for a long
time. The coffee powder
turns bad.
Use fresh coffee powder, or
store unused coffee powder
in a cool, dry place. After
opening a package of coffee
powder, reseal it tightly and
store it in a refrigerator to
maintain its freshness.
The coffee maker
cannot work
any more.
The power outlet is not
plugged well.
Plug the power cord into a
wall outlet correctly, if the
appliance still does not work,
please contact the authorised
service for repairing.
The steam
cannot froth.
The steam ready indicator is
not illuminated.
Only after the steam ready
indicator is illuminated, the
steam can be used to froth.
The container is too big or the
shape is not fit.
Use high and narrow cup.
You have used skimmed milk
Use whole milk or half-
skimmed milk
To Next Page
Loading...
