Haes Esento Eclipse ECL-2 - Page 2

IMPORTANT NOTE
PLEASE READ THIS MANUAL BEFORE HANDLING THE EQUIPMENT AND
OBSERVE ALL ADVICE GIVEN IN IT
THIS PARTICULARLY APPLIES TO THE PRECAUTIONS NECESSARY TO AVOID
E.S.D
The panel is safe to operate provided it has been installed in compliance with the manufacturer’s instructions The panel is safe to operate provided it has been installed in compliance with the manufacturer’s instructions
and used in accordance with this manual.and used in accordance with this manual.
Hazardous voltages are present inside the panel—DO NOT open it unless you are qualied and authorised Hazardous voltages are present inside the panel—DO NOT open it unless you are qualied and authorised
to do so. There is no need to open the panel’s enclosure except to carry out commissioning, maintenance to do so. There is no need to open the panel’s enclosure except to carry out commissioning, maintenance
and remedial work. This work must only be carried out by competent service personnel who are fully and remedial work. This work must only be carried out by competent service personnel who are fully
conversant with the contents of the panel’s installation manual and have the necessary skills for maintaining conversant with the contents of the panel’s installation manual and have the necessary skills for maintaining
this equipment.this equipment.
This re alarm system requires periodic checks as specied in BS 5839 Part 1 It is the responsibility of the This re alarm system requires periodic checks as specied in BS 5839 Part 1 It is the responsibility of the
system user to ensure it is regularly serviced and maintained in good working order.system user to ensure it is regularly serviced and maintained in good working order.
DisclaimerDisclaimer
No responsibility can be accepted by the manufacturer or distributors of this re alarm panel for any No responsibility can be accepted by the manufacturer or distributors of this re alarm panel for any
misinterpretation of an instruction or guidance note or for the compliance of the system as a whole. The misinterpretation of an instruction or guidance note or for the compliance of the system as a whole. The
manufacturer’s policy is one of continuous improvement and we reserve the right to make changes to manufacturer’s policy is one of continuous improvement and we reserve the right to make changes to
product specications at our discretion and without prior notice. E & O E.product specications at our discretion and without prior notice. E & O E.
IMPORTANT SAFETY NOTES
0832
Haes Technologies Ltd, Unit 3 Horton Industrial Park, West Drayton, UB7 8JD
13
Model Number CPD Number
Eclipse 2-4 zone conventional panel ECL-2/4 0832-CPD-2176
European Standard EN54-2 : 1997 + A1 : 2006
Control and indicating equipment for re detection and re alarm systems for buildings.
Provided Options (with requirements):
Output to re alarm devices, dependency type ‘A’, test condition
European Standard EN54-4 : 1997 + A1 : 2002 + A2 : 2006
Power supply equipment for re detection and re alarm systems for buildings.
ATTENTION