hager LCP01X - 7 Installing the Interior Handset Unit; On a Table; On a Wall

This chapter describes how to move the handset unit from a “table” position (in which the
handset unit is normally placed at this stage in the installation, see chapter on Charging the
handset unit before installation) to a “wall” position.
1. Remove the handset from the base.
2. IMPORTANT: the removable transparent cover
must be in place when fixing the unit to the
wall. If this is not the case, clip it back on.
3. Disconnect the power pack.
Electrical shock
hazard
The table mounting procedure is described in the chapter on Charging the handset unit before
installation.
204
GB
7. Installing the interior handset unit
7.1 On a table
7.2 On a wall