hager LCP01X - Creating the Radio Link between the Handset and the Controller

1. At this stage in the installation procedure,
the handset should display:
If this is not the case, the handset needs to
be charged (see chapter on Charging the
handset before installation) until the
language selection message is displayed.
2. Pick up the handset, open the cover and
select the desired language (1) using the
following keys
then .
The handset beeps for 2 sec.
3. Programme the time (1):
A/ set the first digit using the keys
B/ set the next digit using the key .
C/ return to steps A and B to set the minutes
and then, once the desired time has been
programmed, press .
The handset beeps for 2 sec.
4. The handset then moves on to radio link
set-up mode and displays:
5. Pick up the handset, stand next to the controller and follow the procedure on the next page:
The key selects the previous character
IMPORTANT: each call button on the outdoor caller unit can be linked via radio with up to 4 handsets.
200
GB
5.5 Creating the radio link between the handset and the controller
(1) These parameters can be modified at a later stage (see User manual/Modifying handset operating options/Modifying
options for use).