211
GB
Configuring an OPTWIN installation consists in:
• creating radio links between the different transmitter and receiver products to define who
controls who and who sends information to whom.
• allocating a function to each radio link, e.g. when the Light button on the handset is pressed,
this activates the lighting controlled by the output receiver for 5 minutes.
A radio link is created and a function is allocated to this radio link as part of the same procedure.
This procedure is as follows:
Transmitter Receiver
1. Switch to radio link creation mode.
2. Switch to radio link creation mode.
3. Select the function.
4. Select the button or event
associated with the function.
5. Validate the procedure.
To Next Page
Loading...
