hager
"DALI Gateway C00Cx2" software
Functional description
Seite 34 von 130
After the import has been confirmed the plug-in will ask whether the import is to take place with or
without KNX/EIB group addresses (cf. figure 10).
When importing without group addresses the plug-in will not transfer any associations between
communication objects and group addresses of the XML file. Objects are not associated with any group
addresses after the import.
It is also possible to import a XML file with the KNX/EIB group addresses stored in the file. Before
transferring, the plug-in will check all group addresses stored in the XML file. The plug-in will discard
the group addresses if they have either not been created in the current ETS project or if (in case they
are available) are of the wrong data type.
Figure 10: Import dialogue with or without KNX/EIB group addresses
• The import will also overwrite all DALI commissioning parameters (detected DALI devices and group
assignments) with the data of the XML file. It must be pointed out that only the data stored in the ETS
database will be adjusted. A prior DALI commissioning including the programming of the DALI
devices will remain in the DALI devices. For this reason, a new DALI commissioning should always
be carried out after the import of an XML file.
To Next Page
Loading...