04
LED displays in normal operation
witty charging station
02 LED displays in normal operation
LED display Signal Cause LED display Signal Cause
O − The charging station is not
switched on/not receiving
power
2 x − The RFID card has not
been recognised, repeat the
procedure
On − The RFID card is being
checked, and confirmed
during teach-in process, or
− There is a communication
problem with a connected
server
− The charging operation is in
progress (max. power)
− There is a local
communication problem
with the Ethernet/WiFi
− The charging station is
reserved
[3]
− The charging station is ready
or the charging operation is
complete
− The charging operation is
not complete, the electric
vehicle is waiting
[3]
, or
− The WiFi hotspot/coupling
mode is enabled
[3]
2 x − The RFID card has been
accepted, the charging
station is waiting for the
electric vehicle to be
connected/disconnected
− The charging operation is
in progress and is being
monitored and optimised
to protect against overload
(Solar Mode)
[3]
− The charging operation has
been interrupted by the
charging station or
− The charging station
is waiting for RFID
authentication
Table 1: LED displays in normal operation
[3]
Not applicable to all charging stations (version-dependent)!
To Next Page
Loading...
