25
<Caulions for the Drain Waler Lifting Pipe >
Installation height shall be less than 280mm.
There should be a right angle with unit, 300mm from unit.
220 280 below
500 below
⑥
Installation of Waterdrainage Pipe
(1) Install water drainage pipe
• Pipe dia,
shall be equal or larger than that of unit piping. (Pipe of polyethylent; size 25mm; O.D 32mm)
• Drain pipe should be short,
with a downward slope at least 1/100 toprevent air bag from happening.
• If downward slope can t be made,
take other measures to lift it up.
• Keep a distance of 1-1.5m between suspending brackets,
tomake water hose straight.
• Use the self-provided stiff pipe and clamp
①
with unit. Insert water pipe into water plug until it reaches the white
tape. Tighten the clip until head of the screw is less than 4mm from hose.
• Wind the drain hose to the clip using seal pad
⑨
.
• Insulate drain hose in the room.
To Next Page
Loading...
