Haier AS072XVERA - Page 40

A
Press ON/OFF button
Unit stops running, and when
entering this mode for the next
time, it will show the previous setting
Unit runs at the speed displayed on LCD.
In DRY mode, when room temp.becomes 2 C lower than temp. setting,unit
will run intermittently at LOW speed regardless of FAN setting.
5
Ultra-low air flow
Temp.setting+2 C
Temp.setting
On reaching 2 C lower than temp.
setting,unitwill run in mild DRY mode.
COOL operation starts when room
temp. is higher than temp. setting.
Fan operation
Press ON/OFF button
Unit starts running.
The previous status appears on the display (except. TIMER, SLEEP mode)
Press MODE button. For each press,operation mode changes as follows:
Select Fan operation shows " ", Fan operation starts.
Press ON/OFF button
Unit stops running, and when entering this mode for the next time, it will
show the previous setting.
4
1
2
3
Press FAN button. For each press, fan speed changes as follows:
Note:
In this mode, temp. can't be selected, temp.setting will not
be shown in LCD display.In Fan operation mode, "AUTO"
fan speed is not available. Operation cycles are as follows:
LOW MID HIGH
Unit runs at the speed displayed on LCD.
LOW MID HIGH
ON
OFF
TEMP
HEALTH
FAN
MODE
SLEEP
SWING
CLOCK
TIMER
SET
LOCKLIGHT
RESET
1
2
STERILIZE
HEALTH AIRFLOW
FRESH
CODE
3
4
Remote
controller
AUTO COOL DRY FAN HEAT
Heating operation
Press ON/OFF button
Unit starts running.
The previous status appears on the display (except. TIMER, SLEEP mode)
Press MODE button. For each press,operation mode changes as follows:
Select Heating operation " " appears and Heating operation starts.
1
2
Note: For cooling only type, this function is invalid.
AUTO COOL DRY FAN HEAT
Commercial Air Conditioner Model: AU18/222XFERA
AS072/092/122XVERA
-40-