To Next PageTo Next Page
Need help?Do you have a question about the Haier GE GDT665SMN3ES and is the answer not in the manual?
General| Type | Built-In |
|---|---|
| Control Type | Electronic |
| Number of Wash Cycles | 6 |
| Number of Racks | 2 |
| Interior Lighting | No |
| Leveling Legs | Yes |
| Exterior Style | Traditional |
| Color | Stainless Steel |
| Place settings | 16 |
| Number of programs | 6 |
| Delay start | Yes |
| Half load | Yes |
| Child lock | Yes |
| Water Filtration System | Hard Food Disposer |
| Dispenser | Detergent, Rinse Aid |
| Upper Rack Features | Adjustable |
| Lower Rack Features | Foldable tines |
| Noise level | 46 dBA |
| Drying system | Condensation drying |
Mandatory safety procedure for disabling power before commencing repairs.
Diagnosing issues indicated by flashing lights on the control panel.
Troubleshooting steps for a dishwasher that fails to start.
Diagnosing and resolving issues related to a tripped CSM.
Identifying and exiting the demo mode to restore normal operation.
Step-by-step instructions for safely removing the dishwasher door.
Step-by-step guide for removing the detergent module.
Procedures for testing the detergent module's solenoid and resistance.
General information on critical errors that halt dishwasher operation.
Troubleshooting steps for UI display or LED issues.
Information on the main control's service LED and power status.
Procedure for entering and using consumer error mode for diagnostics.
Procedure for accessing service mode to perform diagnostic tests.
Methods for checking main control and UI board functionality.
Troubleshooting steps and tests for CSM trips and related issues.
Detailed steps for accessing and removing the main control board.
Error display and troubleshooting for failure to detect water.
Error display and troubleshooting for pressure sensor signal faults.
Error display and troubleshooting for prolonged water filling.
Procedure for testing pressure sensor power and signal output.
Step-by-step instructions for removing the pressure switch.
Introduction to the Clear Door tool for diagnosing wash performance.
Procedure for using the Clear Door tool to observe spray arm operation.
Information on the motor fuse on the main control board.
Step-by-step instructions for removing the circulation pump motor assembly.
Procedure for testing the diverter sensor and switches.
Instructions for removing the turbidity sensor from the sump.
Troubleshooting steps for turbidity sensor failures.
Procedure for removing the main water conduit.
Common symptoms indicating a failure to drain issue.
Steps to diagnose and identify the cause of drainage problems.
Details the Calrod heater operation during various dry cycles.
Procedures for removing the heat element.
Description and location of the Tub Thermal Cut Off device.
