To Next PageTo Next Page
Need help?Do you have a question about the Haier GE GDT645SYN3FS and is the answer not in the manual?
General| Type | Built-In |
|---|---|
| Number of Wash Cycles | 4 |
| Number of Place Settings | 16 |
| Drying System | Heated Dry |
| Wash Levels | 3 |
| Water Filtration System | Yes |
| Number of Racks | 3 |
| Upper Rack Features | Adjustable |
| Interior Lighting | No |
| Energy Star Certified | Yes |
| Delay Start | Yes |
| Soil Sensor | Yes |
| Third Rack | Yes |
| Stainless Steel Tub | Yes |
| Dispenser | Rinse Aid and Detergent |
| Height | 34 inches |
| Depth | 24 in |
| Control Type | Electronic Touch |
| Dimensions (H x W x D) | 34 in x 24 in x 24 in |
Mandatory Lockout/Tagout procedure for GEA Factory Service Technicians.
Explanation of letters and numbers in model numbers for identification.
Common causes and checks for a dishwasher that will not start.
Location and connection details for the main electrical junction box.
Overview of the door balance system components like springs, cables, and rollers.
Step-by-step guide for installing the tub gasket correctly.
Procedure for replacing the door latch and switch assembly.
Step-by-step guide to safely remove the dishwasher door.
Steps to remove the power dry system components.
Step-by-step guide to remove the detergent module.
Overview of critical errors causing cycle shutdown and displays.
Procedure to enter consumer error mode for diagnostics.
Procedure to enter Service Mode, noting CSM reset.
Diagnostic steps for CSM and heater testing.
Steps to access the main control board for inspection or replacement.
Error code H20 or blinking LED when no water level change occurs.
Error codes PrS/PrF or blinking LEDs due to sensor issues.
Error code CFE or blinking LEDs indicating a constant fill condition.
Steps to test pressure sensor power and signal output.
Steps to remove the water valve assembly.
Tool for diagnosing wash zones, rotation, and leaks.
Procedure to remove the circulation pump motor assembly.
Diagnostic steps for the diverter sensor/switch.
Diagnostic steps for troubleshooting drain issues.
Table of heater algorithms and dry times.
Troubleshooting flowchart for a non-functional heat element.
Steps to remove heater without removing unit.
Steps to remove heater after uninstalling unit.
Description of the power dry fan and its operation.
