– 10 –
Operation and Cycle Information
This section of the guide provides details on segments of cycles, timing of cycles, temperature
expectations, and cycling of the heater during the dry portion of a cycle.
Auto Hot Start
At the beginning of the main wash, the dishwasher checks the temperature of the water, and if it is
below 90°F, then it will add up to 10 minutes of time to heat the water to 90°F by circulating the water
while the heater is on. Similarly, at the beginning of nal rinse, the dishwasher will check the water
temperature, and if it is below 105°F, then it will add up to 15 minutes of time to heat the water to 105°F.
Once it reaches the target temperature, any remaining hot start time will be truncated and will continue
on with the cycle.
The cycle chart explains the segments of a cycle (cycles for all models included, not all models contain
the same cycles). It details ll and drain times which depend on either a full or partial drain. It provides
the circulation time in each segment but does not include turbidity or temperature adjustments or dry
cycles (see the Dry System section in this guide). Times will vary depending on turbidity response and
incoming water temperature.
Cycle Option Selected Light 1-Hour
Normal
Sensor
Auto Heavy
All Zones
No Options
51 60 80 107 143
Boost
Dry
155 164 184 211 247
Heated
Dry
115 124 128 127 207
Bottle
Wash
74 83 103 130 166
Temp
Boost
111 129 156
Sani-Steam
155 171 176
Bottle
Wash
Boost
Dry
178 187 207 234 260
Temp
Boost
Boost
Dry
215 233 260
Sani-Steam
Boost
Dry
259 275 280
Bottle
Wash
Heated
Dry
138 147 151 150 230
Temp
Boost
Heated
Dry
175 149 220
Sani-Steam
Heated
Dry
219 235 240
Temp
Boost
Bottle
Wash
Boost
Dry
238 256 283
Sani-Steam
Bottle
Wash
Boost
Dry
282 298 303
Sani-Steam
Temp
Boost
Boost
Dry
259 275 280
Temp
Boost
Bottle
Wash
Heated
Dry
198 172 243
Sani-Steam
Bottle
Wash
Heated
Dry
242 258 263
Sani-Steam
Temp
Boost
Heated
Dry
219 235 240
Sani-Steam
Temp
Boost
Bottle
Wash
Boost
Dry
282 298 303
Sani-Steam
Temp
Boost
Bottle
Wash
Heated
Dry
242 258 263