Haier GWT750AW - Drain Hose and Electrical Setup

English
English
StepsforInstallation
• Selectasuitablelocationforthewasheronahardevensurfaceawayfrom
directsunlightorheatsourcee.g.radiators,baseboardheaters,cooking
appliancesetc.Anyfloorunevennessshouldbecorrectedwiththeleveling
legslocatedonthebottomcornersofthewasher.Thewashermustbeplaced
atroomtemperature.Youmustnotplacewasherwherethetemperatureisat
belowfreezing.
Installing Your Washer
Readinstallationinstructionscarefullybeforeinstallation.
CAUTION:If,aftercompletingthesesteps,youareunsurethatunitisproperly
installed,contactaqualifiedinstaller.Toensurethatyourwasheris
properlyinstalleditisrecommendedthatitbeinstalledbyacertified
installer.
1.Donotusewaterinlethoseswithoutaflatwasheroneachend.Thewasher
inthecouplinghastobeplacedfirmly.Flatwaterinlethosewashersare
preinstalledineachendofthewaterinlethoses.
NOTE:Youmayhavetouseplierstotightenthecoupling.
Donotovertightenbecauseyoumaycausedamagetothevalve.
2.Connectthehotandcoldwaterinlethosestothehotandcoldwaterfaucet.
7