Getting Started
① Power On
Immediately after the power on, the temperature is displayed as the actual temperature of the
refrigerating and freezing chamber. At this time, the set temperature for refrigerating is 5℃, the set
temperature for freezing is -18℃, Light Wave Fresh light is on, and the buttons are in unlocked
stutus.
The refrigerator has Power Outage Memory function. At every power on after the first power on the
refrigerator will run under the settings set at the last time. (See “Power Outage Memory Function”
for details)
② Operation Mode of the Refrigerator
Within the applicable temperature range of the refrigerator, as long as you selected the
Fuzzy Mode, you will not need to adjust other settings to maintain the best freezing
effect regardless of the ambient temperature changes. Make you worry less and work
less.
You may select one of the two modes bellow to set your refrigerator as needed.
(1) Fuzzy Mode: We recommend using the Fuzzy Mode, if where is no special need.
(See “Fuzzy Function Setting” for details)
(2) Manual Mode: The temperature can be set by using temperature control button.
(See “Temperature Setting and Adjustment” for details)
③ Put the food into your refrigerator
After running for a while, the inside of the
refrigerator is sufficiently cooled. At this time,
food can be put into the refrigerator.
Note: small freezer drawer may be removed
before putting food into large freezer drawer in
order to put more food.
④ If you have lots of fresh food (such as fresh
meat) to put into Freezing Chamber, please
start “Super Freezing” function 12 hour before.
When the temperature setting changes, the inner temperature will be balanced after a
while. The length of the period depends on the changes made to the temperature
setting, the ambient temperature, door-open times, and the food stored in the
refrigerator.
Downloaded from www.vandenborre.be
To Next Page
Loading...
